126. Why does the data communication industry use the layered OSI reference model? (Choose two.)
A. It divides the network communication process into smaller and simpler components, thus aiding componentdevelopment, design, and troubleshooting.
B. It enables equipment from different vendors to use the same electronic components, thus saving research and development funds.
C. It supports the evolution of multiple competing standards, and thus provides business opportunities for equipment manufacturers.
D. It encourages industry standardization by defining what functions occur at each layer of the model.
E. It provides a means by which changes in functionality in one layer require changes in other layers.
Answer: AD
127. Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network. The network administrator connected to router Coffee via the console port, issued the show ip route command, and was able to ping the server. Based on the output of the show ip route command and the topology shown in the graphic, what isthe cause of the failure?
![]() |
A. The network has not fully converged.
B. IP routing is not enabled.
C. A static route is configured incorrectly.
D. The FastEthernet interface on Coffee is disabled.
E. The neighbor relationship table is not correctly updated.
F. The routing table on Coffee has not updated .
Answer: C
128. The network security policy requires that only one host be permitted to attach dynamically to each switchinterface. If that policy is violated, the interface should shut down. Which two commands must the networkadministrator configure on the 2950 Catalyst switch to meet this policy? (Choose two.)
A. Switch1(config-if)# switchport port-security maximum 1
B. Switch1(config)# mac-address-table secure
C. Switch1(config)# access-list 10 permit ip host
D. Switch1(config-if)# switchport port-security violation shutdown
E. Switch1(config-if)# ip access-group 10
Answer: AD
129. What is the maximum data rate specified for IEEE 802.11b WLANs?
A. 10 Mbps
B. 11 Mbps
C. 54 Mbps
D. 100 Mbps
Answer: B
130. Refer to the exhibit. A network associate has configured OSPF with the command:City(config-router)# network 192.168.12.64 0.0.0.63 area 0After completing the configuration, the associate discovers that not all the interfaces are participating in OSPF.Which three of the interfaces shown in the exhibit will participate in OSPF according to this configurationstatement? (Choose three.)
![]() |
A. FastEthernet0 /0
B. FastEthernet0 /1
C. Serial0/0
D. Serial0/1.102
E. Serial0/1.103
F. Serial0/1.104
Answer: BCD
回书目 上一节 下一节 |