您所在的位置:读书频道 > 考试认证 > 思科 > CCNA 640-802 V14 题库(76-80)

CCNA 640-802 V14 题库(76-80)

2008-07-17 10:36 佚名 51CTO.com 字号:T | T
一键收藏,随时查看,分享好友!

本文内容为Testinside CCNA 640-802 V14 最新题库(76-80)试题及答案。

AD:

76. What is the purpose of the command shown below?vtp password Fl0r1da

A. It is used to validate the sources of VTP advertisements sent between switches.

B. It is used to access the VTP server to make changes to the VTP configuration.

C. It allows two VTP servers to exist in the same domain, each configured with different passwords.

D. It is the password required when promoting a switch from VTP client mode to VTP server mode.

E. It is used to prevent a switch newly added to the network from sending incorrect VLAN information to theother switches in the domain.

Answer: A

77. A single 802.11g access point has been configured and installed in the center of a square office. A few wirelessusers are experiencing slow performance and drops while most users are operating at peak efficiency. What arethree likely causes of this problem? (Choose three.)

A. mismatched TKIP encryption

B. null SSID

C. cordless phones

D. mismatched SSID

E. metal file cabinets

F. antenna type or direction

Answer: CEF

78. A network administrator needs to force a high-performance switch that is located in the MDF to become the root bridge for a redundant path switched network. What can be done to ensure that this switch assumes the role as root bridge?

A. Establish a direct link from the switch to all other switches in the network.

B. Assign the switch a higher MAC address than the other switches in the network have.

C. Configure the switch so that it has a lower priority than other switches in the network.

D. Configure the switch for full-duplex operation and configure the other switches for half-duplex operation.

E. Connect the switch directly to the MDF router, which will force the switch to assume the role of root bridge.

Answer: C

79. Refer to the exhibit. Given the output of the Floor3 switch, what statement describes the operation of thisswitch?

  

A. VTP is disabled on this switch.

B. The switch can create, change, and delete VLANs.

C. The switch learns VLAN information but does not save it to NVRAM.

D. The switch can create VLANs locally but will not forward this information to other switches.

E. The switch learns VLAN information and updates the local VLAN data base in NVRAM.

Answer: C

80. What is the effect of the following access list condition? access-list 101 permit ip 10.25.30.0 0.0.0.255 any

A. permit all packets matching the first three octets of the source address to all destinations

B. permit all packets matching the last octet of the destination address and accept all source addresses

C. permit all packets from the third subnet of the network address to all destinations

D. permit all packets matching the host bits in the source address to all destinations

E. permit all packets to destinations matching the first three octets in the destination address

Answer: A

【责任编辑:夏书 TEL:(010)68476606】

回书目   上一节   下一节

分享到:

关于CCNA  认证考试  640-802  V14  最新题库的更多文章

  1. Linux服务器配置全程实录
  2. 揭秘--优秀PPT这样制作

热点职位

更多>>

热点专题

更多>>

读书

非常网管——网络应用
在网络应用越来越复杂的今天,传统的网络应用已经不能满足企业和用户的需要,这就对网络管理员、信息管理部门提出了更高的要求。

51CTO旗下网站

领先的IT技术网站 51CTO 领先的中文存储媒体 WatchStor 中国首个CIO网站 CIOage 中国首家数字医疗网站 HC3i 51CTO学院